Table of Contents
Advertisement
5. Install the cover.
6. Reconnect the external cables and power cords.
7. Turn on the attached devices and the server.
Replacing a hard disk drive
Removing a hard disk drive
About this task
Important:
To ensure adequate system cooling, do not operate the server for more than 2 minutes
without either a hard disk drive or a filler panel installed in each bay.
Important:
Always use an electrostatic-discharge wrist strap or other grounding system when you work
inside the server. For more information, see
Procedure
1. Slide the release latch (orange) gently to the left to unlock the drive handle. See the
Maintaining the Avaya S8800 Server for Avaya Aura
following figure.
1
2
Protecting against ESD damage
Drive tray assembly
Drive handle
®
Communication Manager
Replace the hardware components
on page 10.
July 2012
33
Advertisement
Table of Contents
Troubleshooting
