Jnp10K-Pwr-Ac2 Power Supply Leds - Juniper PTX10008 Hardware Manual

NOTE: If the INP1 or INP2 LED and the PWR OK LED are unlit, the AC power cable is not installed
properly or the power supply has failed.
If the INP1 or INP2 LED is lit and the PWR OK LED is unlit, the AC power supply is not installed
properly or the power supply has an internal failure.
SEE ALSO
Power Requirements for PTX10000 Components | 165
PTX10008 Power Planning
PTX10000 Power Cables Specifications | 172
Connecting AC Power to a PTX10000 | 235

JNP10K-PWR-AC2 Power Supply LEDs

The JNP10K-PWR-AC2 power supply has four LEDs on its faceplate: !, OK, 2, and 1. These LEDs display
information about the status of the power supply. See Figure 34 on page 73.
72