Juniper PTX10008 Hardware Manual page 274

NOTE: You can install the power supplies in any slot labeled PSU 0 through PSU 5 (top to
bottom) on a PTX10008, and PSU 0 through PSU 9 on a PTX10016.
8. Using both hands, place the power supply in the power supply slot on the rear of the system.
9. Slide the power supply straight into the chassis until the power supply is fully seated in the slot. Ensure
the power supply faceplate is flush with any adjacent power supply faceplates or power supply cover
panels (see Figure 140 on page 278
10. Push the captive screw into the power supply faceplate. Ensure that the screw is seated inside the
corresponding hole on the faceplate.
11. Tighten the captive screw by turning it clockwise by using the Phillips (+) screwdriver, number 1. When
the screw is completely tight, the latch locks into the router chassis.
Figure 140: Installing a JNP10K-PWR-AC Power Supply in a PTX10008
Keep latch in open position during installation.
and Figure 141 on page 279).
278