Juniper PTX10008 Hardware Manual page 295

To install a JNP10K-PWR-DC power supply in a PTX10000 (see
1. Attach the electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
the ESD point on the chassis. There is an ESD point located next to the protective earthing terminal
and below PSU 5 on the PTX10008 rear panel (see
PTX10016 rear panel (see
Figure 161: ESD Point on PTX10008 Chassis Rear
1 ESD point
—
Figure 162: ESD Point on PTX10016 Chassis Rear
1
1 ESD point
—
2. Taking care not to touch power supply components, pins, leads, or solder connections, remove the
power supply from its bag.
CAUTION:
a few minutes for the power supply to cool by pulling the power supply halfway out
of the chassis, or wear heat-resistant gloves while removing the power supply.
Figure 162 on page 299).
See the heat symbol
Figure 167 on page
Figure 161 on page 299) and below PSU_9 on the
. The power supply surfaces are hot. Allow
304):
299