Jnp10K-Pwr-Dc Power Supply - Juniper PTX10008 Hardware Manual

CAUTION:
attached an appropriate grounding lug to the grounding cable that you supply. Using a
grounding cable with an incorrectly attached lug can damage the router.
Table 12: Power Input and Output Voltages for JNP10K-PWR-AC2 Power Supplies
INP0 (Switch 1) INP1 (Switch 2)
On On
On On
On Off
Off On
On Off
Off On
The JNP10K-PWR-AC2 requires the enhanced power bus to operate at full power. You can use the standard
bus, but available power is 3000 W for power budget from the power management software. To determine
whether your system has the standard power bus or the enhanced power bus, see
Panel LEDs" on page 41.

JNP10K-PWR-DC Power Supply

The PTX10000 supports three types of DC power supply modules:
JNP10K-PWR-DC—A 2500-W, 12-VDC dual power supply.
JNP10K-PWR-DC2—A 5500-W, 12-VDC quad input power supply. For details on this power supply,
see "JNP10K-PWR-DC2 Power Supply" on page
JNP10K-PWR-AC2—An AC, high-voltage alternating current (HVAC,) or high-voltage direct current
(HVDC) power supply. In high power mode, this power supply provides 12.3 V, 5000 W with a single
feed and 5500 W with dual feeds. For details on this power supply, see
Supply" on page 64.
Before you begin installing the router, ensure that a licensed electrician has
H/L (High Input 30 A/Low Input
20A)
On (30 A)
Off (20 A)
On (30 A)
On (30 A)
Off (20 A)
Off (20 A)
68.
"JNP10K-PWR-AC2 Power
Output Power
5500 W
3000 W
5000 W
5000 W
2700 W
2700 W
"PTX10000 Status
65