Juniper PTX10008 Hardware Manual page 316

Table 80: Setting the JNP10K-PWR-DC2 Dip Switches (continued)
Switch State
3 On
Off
Figure 186: Setting the Enable Switches for the Power Source
1 Dip switches
—
19. Verify that the input 1 and 2 LEDs on the power supply faceplate are lit and are on steadily.
20. Press the power switch to the on (|) position.
RELATED DOCUMENTATION
JNP10K-PWR-AC Power Supply | 61
JNP10K-PWR-DC Power Supply | 65
Connecting AC Power to a PTX10000 | 235
Connecting DC Power to a PTX10000 | 235
Calculating Power Requirements for a PTX10008 | 166
Calculating Power Requirements for a PTX10016 Router
Field
Enabled for 30 A feed; 5500-W for a single feed, 5000-W for dual feeds
Enabled for 20 A feed; power supply capacity is 3000-W
1 2
2 Power switch, on (|) and standby (O)
—
320