Juniper PTX10008 Hardware Manual page 134

Control Security (MACsec) capable. The ports support speeds of 100 Gbps or 40 Gbps and you can configure
the port speed through the CLI.
The PTX10K-LC1105 line card is supported on Junos OS Release 17.4R1-S1 and later.
This topic describes:
Overview
The line cards in PTX10000 Packet Transport Routers combine a Packet Forwarding Engine and Ethernet
interfaces in a single assembly. Line cards are field-replaceable units (FRUs) that can be installed in the
line card slots on the front of the switch chassis. The line cards are hot-insertable and hot-removable; you
can remove and replace them without powering off the switch or disrupting switch functions. See
Figure 59 on page 135.
Figure 59: PTX10K-LC1105 Port Panel
1
1 Power LED, status LED, and offline button
—
Network Ports
Each of the 30 QSFP28 ports supports:
100-Gigabit Ethernet using QSFP28 optical transceivers. When a QSFP28 transceiver is inserted into
any of the ports, the QSFP28 port is enabled for 100-Gigabit Ethernet.
40-Gigabit Ethernet using QSFP+ optical transceivers. When a QSFP+ transceiver is inserted into any
of the ports, the QSFP+ port is enabled for 40-Gigabit Ethernet.
On the PTX10K-LC1105, the ports are enabled by default, and the default configuration adds the ports
to the default VLAN.
Power and Status LEDs
The two LEDs to the left of the network ports indicate the power (PWR) and status (STS) for the line card.
See Table 41 on page 136
2
and Table 42 on page 136.
2 Network ports
—
135