To remove any model of the PTX10000 fan tray (JNP10008-FAN, JNP10008-FAN2, JNP10016-FAN, or
JNP10016-FAN2:
1. Attach the electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
the ESD point on the rear left side of the chassis. See
Figure 118: ESD Point on PTX10008 Chassis Rear
1
-
Figure 119: ESD Point on PTX10016 Chassis Rear
1
ESD point
-
2. Loosen the four captive screws either by unscrewing with your thumb and forefinger or with a Phillips
screwdriver.
3. Grasp the top and bottom handles and pull the fan tray out about 3 in. (7.6 cm). See
Figure 120 on page 261
and
for the PTX10008 and
Figure 122 on page 263
Figure 119 on page
260.
and
260