Juniper PTX10008 Hardware Manual page 322

top of any other component. Place each unit separately in an antistatic bag or on an antistatic mat placed
on a flat, stable surface.
NOTE: Because these units are heavy, and because electrotatic bags are fragile, inserting the line
card into the bag is best done with two people.
To insert a line card, RCB, or SIB into an electrostatic bag:
1. Hold the unit horizontally with the faceplate toward you.
2. Slide the opening of the bag over the connector edge.
If you must insert the line card, RCB, or SIB into a bag by yourself:
1. Lay the unit horizontally on an antistatic mat that is on a flat, stable surface with the sheet metal side
down.
2. Orient the unit with the faceplate toward you.
3. Carefully insert the connector edge into the opening of the bag and pull the bag toward you to cover
the unit.
Installing a PTX10000 Switch Interface Board
A PTX10008 and a PTX10016 router has six Switch Interface Boards (SIBs) that are located in the middle
of the chassis behind the fan trays. SIB 0 through SIB 2 are located behind the left fan tray, and SIB 3
through SIB 5 are located behind the right fan tray. You must remove the appropriate fan tray to install a
SIB. See "Removing a PTX10000 Fan Tray" on page
Ensure you have the following equipment on hand before installing a SIB:
Electrostatic bag or antistatic mat
Electrostatic discharge (ESD) grounding strap
To install a SIB:
1. Place an electrostatic bag or an antistatic mat on a flat, stable surface.
2. Attach the ESD grounding strap to your bare wrist, and connect the strap to the ESD point on the
chassis. There is an ESD point located next to the protective earthing terminal and below PSU 5 on the
258.
326