Juniper PTX10008 Hardware Manual page 188

The calculated power margin is greater than zero, indicating that the link has sufficient power for
transmission. Also, the power margin value does not exceed the maximum receiver input power. Refer
to the specifications for your receiver to find the maximum receiver input power.
PTX10000 Console and Management Cable
Specifications and Pinouts
IN THIS SECTION
Console Port Connector Pinouts for a PTX10000 | 190
USB Port Specifications for the PTX10000 Series | 191
Management Port Connector Pinouts for the PTX10000 Router | 192
Following sections describe the console port, the USB port, and the management port connections and
specifications.
Console Port Connector Pinouts for a PTX10000
The console port (labeled CON) on the Routing and Control Board panel is an RS-232 serial interface that
uses an RJ-45 connector to connect to a console management device. The default baud rate for the console
port is 9600 baud.
Table 71 on page 191 provides the pinout information for the RJ-45 console connector. An RJ-45 cable
and RJ-45 to DB-9 adapter are supplied with the PTX10008 and PTX10016 routers.
NOTE: If your laptop or PC does not have a DB-9 male connector pin and you want to connect
your laptop or PC directly to a PTX10008 router or a PTX10016 router, use a combination of the
RJ-45 cable and RJ-45 to DB-9 adapter supplied with the device and a USB to DB-9 male adapter.
You must provide the USB to DB-9 male adapter.
190