Jnp10K-Pwr-Dc Power Supply Leds - Juniper PTX10008 Hardware Manual

Table 16: Interpreting JNP10K-PWR-AC2 LEDs
LED
INP1 or INP0 in CLI output
INP2 or INP1 in CLI output
OK
!

JNP10K-PWR-DC Power Supply LEDs

The JNP10K-PWR-DC power supply has four LEDs on its faceplate: INP1, INP2, PWR OK, and FAULT.
These LEDs display information about the status of the power supply. See
Color State
Yellow Blinking
Green Solid
Unlit Off
Yellow Blinking
Green Solid
Unlit Off
Green Solid
Yellow Blinking
Red Solid
Unlit Off
Description
The input voltage is present, but is not within normal
operating range.
The input voltage is present and within normal
operating range.
The power supply is switched off; voltage is zero.
The input voltage is present, but is not within normal
operating range.
The input voltage is present and within normal
operating range.
The power supply is switched off; voltage is zero.
The power supply output is within normal operating
range.
The power supply output is out of the power limits
or is over-current position.
Power supply has failed and must be replaced.
Power supply is functioning normally.
Figure 35 on page
74
75.