Juniper PTX10008 Hardware Manual page 70

Figure 33: LEDs on an JNP10K-PWR-AC Power Supply
1 FAULT
—
2 PWR OK
—
Table 14 on page 71 describes the LEDs on a JNP10K-PWR-AC power supply.
Table 14: LEDs on a JNP10K-PWR-AC Power Supply
LED
INP1 (INP0 in CLI output)
or INP2 (INP1 in CLI
output)
PWR OK
FAULT
1 2 3 4
Color State
Yellow Blinking
Green Solid
Dark Unlit
Green Solid
Yellow Blinking
Dark Unlit
Red Solid
3 INP2–Source input 1
—
4 INP1–Source input 0
—
Description
Indicates that the AC power input voltage is not
within normal operating range.
AC is within operating range (200–240 VAC).
The power supply is switched off.
DC power output is within normal operating range.
The output is out of the limits.
Power supply is functioning normally.
Power supply has failed and must be replaced. Or,
only one input is powered and the enabled router
for the input that is not powered is set to ON. See
"How to Install a JNP10K-PWR-AC Power Supply"
on page 274 for more information about the enable
switches.
71