NOTE:
If the INP1 or INP2 and the PWR OK LED are unlit, the power cables are not installed
properly or the power supply has failed.
If the INP1 or INP2 LED is lit green and the PWR OK LED is unlit, the power supply is not installed
properly or the power supply has an internal failure.
If the FAULT LED is blinking, add a power supply to balance the power demand and supply.
SEE ALSO
Power Requirements for PTX10000 Components | 165
PTX10008 Power Planning
Connecting DC Power to a PTX10000 | 235
JNP10K-PWR-DC2 Power Supply LEDs
A JNP10K-PWR-DC2 power supply module has four LEDs on its faceplate: 1, 2, OK, and the symbol for
fault, !. These LEDs display information about the status of the power supply. See
Figure 36: LEDs on a JNP10K-PWR-DC2 Power Supply
1
!–FAULT
—
2
OK–Power okay
—
1
2
3
4
3
2–Source input 1
—
4
1–Source input 0
—
Figure 36 on page
76.
76