Figure - Juniper PTX10008 Hardware Manual

4. Remove the power cords from the AC appliance inlets on the AC power supply faceplate.
5. Turn the adjustment nut of the power cord retainers counterclockwise till you can see the power cord.
Pull the power cord from the slot in the adjustment nuts.
6. Unscrew the captive screw counterclockwise by using the Phillips (+) screwdriver, number 1. See
Figure 134 on page 273
7. Rotate the captive screw away from the faceplate of the power supply to release the latch.
8. Taking care not to touch the power supply output connections, pins, leads, or solder connections, place
one hand under the power supply to support it. Grasp the power supply handle with your other hand
and pull the power supply completely out of the chassis.
CAUTION:
it could damage the power supply.
CAUTION:
a few minutes for the power supply to cool by pulling the power supply halfway out
of the chassis, or wear protective, heat-resistant gloves while removing the power
supply.
9. If you are not replacing the power supply, install the cover over the slot by inserting your thumb and
forefinger into the finger holes, squeezing and pulling the cover out of the slot.
and Figure 135 on page
Do not bump the output connections. If the connection hits a solid object,
See the heat symbol
273.
. The power supply surfaces are hot. Allow
272