Juniper PTX10008 Hardware Manual page 267

1. Attach the electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
the ESD point on the chassis. There is an ESD point located next to the protective earthing terminal
and below PSU 5 on the PTX10008 rear panel (see
PTX10016 (see Figure 133 on page
Figure 132: ESD Point on PTX10008 Chassis Rear
1 ESD point
—
Figure 133: ESD Point on PTX10016 Chassis Rear
1 ESD point
—
2. Flip the Enable switch next to the appliance inlet on the power supply to the standby position.
3. Disconnect power from the router by performing one of the two following tasks:
If the AC power source outlets have a power switch, set them to the off (O) position.
If the AC power source outlets do not have a power switch, gently pull the male end of the power
cords connected to the power source outlets out of the outlets.
Figure 132 on page
271).
271) and below PSU_9 on the
271