Juniper PTX10008 Hardware Manual page 209

Figure 82: Attaching the Chassis Flanges to the Rack
6. Move the lift away from the rack.
7. Attach the chassis to the rack by installing a mounting screw through the open flange holes and rack,
starting from the bottom.
8. Visually inspect the alignment of the router. If the router is installed properly in the rack, all the mounting
screws on one side of the rack are aligned with the mounting screws on the opposite side and the
router is level.
9. After ensuring that the router is aligned properly, tighten the screws.
10. After you install the mounting screws and securely bolt the chassis to the rack, reinstall the components
in the chassis.
Manually Mounting a PTX10008 in a 4-Post Rack
If you cannot use a mechanical lift to install the router (the preferred method), you can install it manually.
212