Juniper PTX10008 Hardware Manual page 250

To install any PTX10000 fan tray (JNP10008-FAN, ,JNP10008-FAN2, JNP10016-FAN, or JNP10016-FAN2
fan tray):
1. Attach the ESD grounding strap to your bare wrist, and connect the strap to the ESD point on the rear
left side of the chassis (see
Figure 112: ESD Point for PTX10008 Chassis Rear
1 ESD point
—
Figure 113: ESD Point for PTX10016 Chassis Rear
1 ESD point
—
2. Grasp the top and bottom fan tray handles and align the bottom of the fan tray with the bottom of the
fan tray slot.
3. Rest the bottom edge of the fan tray in the slot and slide the fan tray into place so it is fully seated.
4. Tighten the captive screws until finger tight. See
Figure 112 on page 254
Figure 114 on page 255
and Figure 113 on page 254
through
).
Figure 117 on page 258.
254