Juniper PTX10008 Hardware Manual page 317

PTX10000 Field-Replaceable Units | 40
Removing and Installing PTX10000 Switch Fabric
Components
IN THIS SECTION
Handling and Storing PTX10000 Line Cards, Routing and Control Boards, and SIBs | 321
Installing a PTX10000 Switch Interface Board | 326
Removing a PTX10000 Switch Interface Board | 332
Each PTX10008 or a PTX10016 router contains six SIBs that are installed vertically, mid-chassis, between
the line cards and the routing and control boards in the front and the fan trays in the rear. To install or
remove the switch interface boards in a PTX10008 router or a PTX10016 router, refer to the following
sections:
Handling and Storing PTX10000 Line Cards, Routing and Control Boards,
and SIBs
IN THIS SECTION
Holding Line Cards and Control Boards | 322
Holding SIBs | 323
Storing Line Cards, Routing and Control Boards, and SIBs | 325
The PTX10008 and PTX10016 chassis have several field-replaceable units (FRUs) that have fragile
components. To avoid damaging the line cards, Routing and Control Boards (RCBs), and Switch Interface
Boards (SIBs), be sure you follow the following safe handling practices. This topic covers:
321