Juniper PTX10008 Hardware Manual page 334

Installing a PTX10000 Line Card
Before you install a line card in the router chassis:
Ensure that you have taken the necessary precautions to prevent electrostatic discharge (ESD) damage.
See "Prevention of Electrostatic Discharge Damage" on page
Ensure that you know how to handle and store the line card. See
Routing Control Boards, and Switch Interface Boards" on page
Inspect the connector edge of the line card for physical damage. Installing a damaged line card might
damage the router.
Ensure that the router has sufficient power to power the line card while maintaining its n+1 power
redundancy. To determine whether the router has enough power available for the line card, use the
show chassis power-budget-statistics command.
The PTX10K-LC1101 requires 1150 W
The PTX10K-LC1102 requires 675 W
Ensure that you have the following parts and tools available to install a line card in the router:
ESD grounding strap
Phillips (+) screwdriver, number 2
427.
"Unpacking PTX10000 Line Cards,
200.
338