Juniper PTX10008 Hardware Manual page 190

RE-USB-4G-S—4-GB USB flash drive
CAUTION:
has not been tested by Juniper Networks. The use of any unsupported USB memory
product could expose your device to unpredictable behavior. Juniper Networks Technical
Assistance Center (JTAC) can provide only limited support for issues related to
unsupported hardware. We strongly recommend that you use only supported USB flash
drives.
CAUTION:
PTX10000 routers. Failure to do so could expose your device to unpredictable behavior.
NOTE: USB flash drives used with the PTX10000 router must support USB 2.0 or later.
SEE ALSO
Creating an Emergency Boot Device | 365
Performing a Recovery Installation Using an Emergency Boot Device | 368
Management Port Connector Pinouts for the PTX10000 Router
The 1000BASE-T RJ-45 management ports use an RJ-45 connector to connect a management device for
out-of-band management.
Table 72 on page 192 provides the pinout information of the RJ-45 management port connector. An RJ-45
cable is supplied with the PTX10000 router.
Table 72: RJ-45 Management Port Connector Pinouts for the PTX10000 Series
Pin
1
2
Any USB memory product not listed as supported for the PTX10000 Series
Remove the USB flash drive before upgrading Junos OS or rebooting a
Signal
TRP1+
TRP1–
Description
Transmit/receive data pair 1
Transmit/receive data pair 1
192