Table of Contents
Advertisement
Figure 199: Removing the SIB from a PTX10016 Chassis
8. Support the SIB as you rotate the SIB 90 degrees and place it on the antistatic mat with the printed
circuit (PC) board facing upward. Be careful not to bump or handle the SIB by the connectors. If you
do not have an antistatic mat, have another person help you slide the electrostatic bag over the SIB
before placing it on the stable surface. See
CAUTION:
remove them. Place each component on an antistatic mat resting on a stable, flat
surface.
Figure 200 on page
Do not stack hardware components on top of one another after you
337.
336
Hide quick links:
Advertisement
Chapters
Table of Contents
