Table of Contents
Advertisement
NOTE:
Ensure that the ejector is fully open to avoid scratching the chassis.
Figure 141: Installing a JNP10K-PWR-AC Power Supply in a PTX10016
YES
Ejector fully open
12. Manually load balance the power supplies as you attach each power cable to a dedicated AC power
source outlet. To load balance, route the power cables to alternate between power sources. The
JNP10K-PWR-AC does not share power; all power comes into INP1 (lower receptacle) and only uses
INP2 (top receptacle) at fail over. See
NO
Ejector closed
Figure 142 on page 280
for PTX10008 and
Figure 143 on page 280
279
Hide quick links:
Advertisement
Chapters
Table of Contents
