Juniper PTX10008 Hardware Manual page 279

1. Attach the electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
the ESD point on the chassis. There is an ESD point located next to the protective earthing terminal
and below PSU 5 on the PTX10008 rear panel (see
PTX10016 (see Figure 146 on page
Figure 145: ESD Point on PTX10008 Chassis Rear
1
1 ESD point
—
Figure 146: ESD Point on PTX10016 Chassis Rear
1
1 ESD point
—
2. Flip the power | switch next to the appliance inlet on the power supply to the standby position.
3. If the AC or DC power source outlets have a power switch, set them to the off (O) position.
4. Disconnect the Anderson connectors from each input on the JNP10K-PWR-AC2 power supply faceplate.
Figure 145 on page
283).
283) and below PSU_9 on the
283