Juniper PTX10008 Hardware Manual page 301

Figure 168: Installing a DC Power Supply in a PTX10016
Keep latch in open position during installation.
NOTE: Ensure that the ejector is fully open to avoid scratching the chassis.
YES
Ejector fully open
19. Route INP1 cables to a power source and INP2 to another power source. The JNP10K-PWR-DC shares
power, so if power dips on one input, the power supply is able to load balance internally. See
Figure 169 on page 306
NO
Ejector closed
and Figure 170 on page
Close latch after power
supply is fully installed.
Scratches
306.
305