Juniper PTX10008 Hardware Manual page 74

Figure 35: LEDs on a JNP10K-PWR-DC Power Supply
1 INP1–Source input 0
—
2 INP2–Source input 1
—
Table 17 on page 75 describes the LEDs on JNP10K-PWR-DC power supplies.
Table 17: LEDs on a JNP10K-PWR-DC Power Supply
LED
INP1 (INP0 in CLI output)
or INP2 (INP1 in CLI
output)
PWR OK
FAULT
Color State
Yellow Blinking
Green Solid
Unlit Off
Green Solid
Yellow Blinking
Red Solid
Unlit Off
3 PWR OK
—
4 FAULT
—
Description
Indicates that the DC power input voltage is not
within normal operating range.
DC power is within operating range (-40 VDC to -72
VDC).
The power supply is switched off.
DC power output is within normal operating range.
The output is out of the limits.
Power supply has failed and must be replaced.
Power supply is functioning normally. Or, only one
input is powered and the enable switch for the input
that is not powered is set to ON. See
DC Power to a PTX10000" on page 235
information on the enable switches.
75
"Connecting
for more