Juniper PTX10008 Hardware Manual page 62

Each JNP10K-PWR-AC power supply comes with two power cord retainers that hold the power cords in
place. See Figure 28 on page
the clip hook into the bracket holes on each side of the AC appliance inlet on the faceplate. The adjustment
nut holds the power cord in the correct position. For instructions for installing the power cord retainers,
see "Connecting AC Power to a PTX10000" on page
NOTE: Route all the AC power supply cords away from the fan trays. Make sure that the power
cords do not obstruct the fan trays.
Figure 28: Power Cord Retainer for an JNP10K-PWR-AC Power Supply
Each power supply connects to the power rail in the router. The power rail distributes the output power
produced by the power supplies to different router components. Each power supply provides power to
all the components in the router.
Each power supply has its own fan and is cooled by its own internal cooling system. Hot air exhausts from
the rear of the chassis.
SEE ALSO
JNP10K-PWR-AC Power Specifications | 171
How to Install a JNP10K-PWR-AC Power Supply | 274
How to Remove a JNP10K-PWR-AC Power Supply | 270
63. Each power cord retainer has a clip and an adjustment nut. The ends of
235.
63