Juniper PTX10008 Hardware Manual page 237

[edit]
root@# set system host-name host-name
7. Configure the default gateway.
[edit]
root@# set routing-options static route default next-hop address
8. Configure the IP address and prefix length for the router management interface.
[edit]
root@# set interfaces em0 unit 0 family inet address address/prefix-length
CAUTION:
interfaces within the same subnet, only one interface is usable and supported.
NOTE: The management ports, em0 (MGMT for RJ-45 connections) and em1 (also labeled
MGMT for fiber connections), are found on the port panel of the Control Boards of the PTX10008
router. and the PTX10016 router.
9. (Optional) Configure the static routes to remote prefixes with access to the management port.
[edit]
root@# set routing-options static route remote-prefix next-hop destination-ip retain no-readvertise
10. Enable Telnet service.
[edit]
root@# set system services telnet
NOTE: When Telnet is enabled, you cannot log in to a PTX10000 through Telnet using root
credentials. Root login is allowed only for SSH access.
11. Commit the configuration to activate it on the router.
[edit]
root@# commit
Although the CLI permits you to configure two management Ethernet
240