Juniper PTX10008 Hardware Manual page 313

14. Using both hands, place the power supply in the power supply slot on the rear of the router. Slide the
power supply straight into the chassis until the power supply is fully seated in the slot. The power
supply will protrude from the chassis about 2 in. (5 cm) (see
Figure 183 on page 318).
15. Push the captive screw into the power supply faceplate. Ensure that the screw is seated inside the
corresponding hole on the faceplate.
16. Tighten the captive screw by turning it clockwise by using the Phillips (+) screwdriver, number 1. When
the screw is completely tight, the latch locks into the router chassis.
Figure 182: Installing a JNP10K-PWR-DC2 in PTX10008
Figure 182 on page 317
317
and