Juniper PTX10008 Hardware Manual page 197

8. Use a 13/32 in. (10 mm) open-end or socket wrench to remove the four sets of bracket bolts that
secure the chassis to the shipping pallet (see
Figure 78: Bracket Bolt Removal
9. Unpack the accessory box and lay out the contents so that they are ready for use.
10. Verify that your order includes all appropriate parts. See
on page 202 and "PTX10008 Components and Configurations" on page 35
configurations and redundant configurations.
11. Store the brackets and bolts inside the accessory box.
12. Save the shipping box and packing materials in case you need to move or ship the router at a later time.
Unpacking PTX10000 Line Cards, Routing Control Boards, and Switch
Interface Boards
Orders for line cards, additional Routing and Control Boards (RCBs), and SIB components are FRUs that
are shipped separately from the router chassis. The housing for the RCBs and line cards are rigid sheet-metal
structures that house the electronics. SIBs have an exposed printed circuit board on one side and sheet
metal on the other. All these components are shipped in a cardboard carton, secured with packing material.
Figure 78 on page 200).
"Comparing the PTX10000 Order to the Pack"
for information about base
200