Juniper PTX10008 Hardware Manual page 245

4. Lift the RCB by its sides, being careful not to bump the connectors.
5. Carefully align the sides of the RCB with the guides inside the chassis.
6. Slide the RCB into the chassis, carefully ensuring that it is correctly aligned.
7. Grasp both handles and rotate them simultaneously clockwise until the RCB is fully seated and the
handles are vertical (see
Figure 108: Routing and Control Board Installation
The RCB begins the power-on sequence when fully seated.
8. To verify that the RCB is functioning normally, check the PWR LED on its faceplate and the CONTROL
BOARDS LED on the status panel. Both LEDs should light steadily shortly after the RCB is installed. If
the PWR LED is blinking yellow, there might be insufficient power available. See
Planning" on page 164
that you have adequate power for the additional unit.
Another method of verifying that the RCB is online is to use the CLI command:
user@host> show chassis environment cb
SEE ALSO
Power Requirements for PTX10000 Components | 165
PTX10008 Power Planning
PTX10000 Routing and Control Board LEDs | 81
Figure 108 on page 249).
PT X1 00 08
and "Power Requirements for PTX10000 Components" on page 165
"PTX10008 Power
to ensure
249