Juniper PTX10008 Hardware Manual page 283

To install a JNP10K-PWR-AC2 power supply in a PTX10008 or a PTX10016:
1. Attach the electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
the ESD point on the chassis. There is an ESD point located next to the protective earthing terminal
and below PSU5 on the PTX10008 rear panel (see
PTX10016 (see Figure 150 on page
Figure 149: ESD Point on the PTX10008 Chassis Rear
1
1 ESD point
—
Figure 150: ESD Point on PTX10016 Chassis Rear
1
1 ESD point
—
2. If the power supply slot has a cover on it, insert your thumb and forefinger into the finger holes, squeeze,
and pull the cover out of the slot. Save the cover for later use. See
on a PTX10008 and
287).
Figure 152 on page 288
Figure 149 on page
Figure 151 on page 288
for the PTX10016.
287) or below PSU9 on the
for removal
287