Jnp10K-Pwr-Ac2 Power Supply Leds - Juniper MX10008 Hardware Manual

JNP10K-PWR-AC2 Power Supply LEDs

The JNP10K-PWR-AC2 power supply has four LEDs on its faceplate: !, OK, 2, and 1. These LEDs display
information about the status of the power supply. See
Figure 34: LEDs on a JNP10K-PWR-AC2 HVDC Power Supply
1 2
1 ! FAULT
—
2 OK PWR OK
—
NOTE: Physical markings on the power supply are INP1 and INP2. These markings correspond to
INP0 and INP1 in the show chassis power output (see
Table 17: Physical Markings on Chassis Versus Show Chassis Power Command
Physical Marking on JNP10K-PWR-AC2
INP1
INP2
Table 18 on page 73 describes the LEDs on a JNP10K-PWR-AC2 power supply.
Figure 34 on page
3 4
3 2 INP2–Source input 1
—
4 1 INP1–Source input 0
—
Table 17 on page
Show Chassis Power Command
INP0
INP1
72.
72).
72