Juniper PTX10008 Hardware Manual page 345

3. If the port in which you want to install the transceiver is covered with a dust cover, remove the dust
cover and save it in case you need to cover the port later.
4. Using both hands, carefully place the transceiver in the empty port. The connectors must face the
device chassis.
CAUTION:
is aligned correctly. Misalignment might cause the pins to bend, making the transceiver
unusable. Note that on JNP5100-48T devices, the QSFP+ top and bottom ports have
the same orientation for inserting and removing transceivers. On all other PTX10000
routers, the ports are designed belly-to-belly, which requires you to turn the transceiver
over on the bottom port row. See
Figure 217 on page 350
5. Slide the transceiver in gently until it is fully seated. See
inserting an SFP transceiver.
Figure 217 on page 350
product SKU devices.
6. Remove the rubber safety cap when you are ready to connect the cable to the transceiver.
WARNING:
fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected to
transceivers emit laser light that can damage your eyes.
Figure 215: Installing an SFP Transceiver in the PTX10000 Series
Before you slide the transceiver into the port, ensure that the transceiver
Figure 215 on page 349
for the correct orientation for your device.
Figure 216 on page
are examples of inserting QSFP+ transceivers into different PTX10000 Series
Do not look directly into a fiber-optic transceiver or into the ends of
SFP transciever
through
Figure 215 on page 349
350, and Figure 216 on page 350
for an example of
and
349