Juniper PTX10008 Hardware Manual page 244

1. Attach the ESD grounding strap to your bare wrist, and connect the strap to the ESD point on the front
of the chassis (see Figure 105 on page 248
Figure 105: ESD Point for PTX10008 Chassis Front
1 ESD point
—
Figure 106: ESD Point for PTX10016 Chassis Front
2. Either remove the cover from the available RCB slot (see
RCB (see "Removing a PTX10000 Routing and Control Board" on page
Figure 107: Removing a Routing and Control Board Cover
3. Remove the new RCB from the electrostatic bag and inspect it for any damage before installing it into
the chassis.
and Figure 106 on page
1
1
Figure 107 on page
248).
248) or remove the failing
250).
248