Juniper PTX10008 Hardware Manual page 135

Table 41: Power LED
Color State
Unlit Off
Green On steadily
Yellow or amber Blinking
Table 42: Status LED
Color State
Unlit Off
Green On steadily
Yellow or amber On steadily
Blinking
Slow blink or blip
Offline Button
The offline/online button is recessed below the faceplate directly below the status (STS) LED. You can
take the PTX10K-LC1105 offline or online by using either of these two methods:
Press the OFF button with a pin tool, such as a paperclip, until the STS LED goes out (about 5 seconds).
Issue the CLI command:
user@host> request chassis pic fpc-slot fpc-slot pic-slot pic-slot offline
Port Status and Activity LEDs
Each QSFP28 port has a bi-colored up or down LED indicator that show port status and link activity. See
Figure 60 on page 137 and
Description
There is no power to the line card.
The line card has power.
The line card has a power fault.
Description
The line card is offline or disabled.
The line card is online.
The line card is booting.
The line card has a fault condition or alarm.
The beacon function is enabled.
Table 43 on page 137.
136