Service Control Rules; Ftp; Configuring Ftp - ZyXEL Communications ZyWall ATP series User Manual

37.9.2 Service Control Rules

Click the Add or Edit icon in the Service Control table to add a service control rule.
Figure 497 Configuration > System > TELNET > Service Control Rule Add/Edit
The following table describes the labels in this screen.
Table 317 Configuration > System > TELNET > Service Control Rule Add/Edit
LABEL
Create new
Object
Address Object
Zone
Action
OK
Cancel

37.10 FTP

You can upload and download the Zyxel Device's firmware and configuration files using FTP. To use this
feature, your computer must have an FTP client.

37.10.1 Configuring FTP

To change your Zyxel Device's FTP settings, click Configuration > System > FTP tab. The screen appears
as shown. Use this screen to specify from which zones FTP can be used to access the Zyxel Device. You
can also specify from which IP addresses the access can come.
Chapter 37 System
DESCRIPTION
Use this to configure any new settings objects that you need to use in this screen.
Select ALL to allow or deny any computer to communicate with the Zyxel Device using Telnet.
Select a predefined address object to just allow or deny the computer with the IP address that
you specified to access the Zyxel Device using Telnet.
Select ALL to allow or prevent any Zyxel Device zones from being accessed using Telnet.
Select a predefined Zyxel Device zone on which a incoming service is allowed or denied.
Select Accept to allow the user to access the Zyxel Device from the specified computers.
Select Deny to block the user's access to the Zyxel Device from the specified computers.
Click OK to save your customized settings and exit this screen.
Click Cancel to exit this screen without saving
ZyWALL ATP Series User's Guide
730