ZyXEL Communications ZyWall ATP series User Manual page 186

Each field is described in the following table.
Table 76 Configuration > Wireless > AP Management > Mgnt. AP List
LABEL DESCRIPTION
Edit Select an AP and click this button to edit its properties.
Remove Select an AP and click this button to remove it from the list.
Note: If in the Configuration > Wireless > Controller screen you set the Registration
Reboot Select an AP and click this button to force it to restart.
DCS Now Select one or multiple APs and click this button to use DCS (Dynamic Channel Selection) to
allow the AP to automatically find a less-used channel in an environment where there are
many APs and there may be interference.
Note: You should have enabled DCS in the applied AP radio profile before the
Note: DCS is not supported on the radio which is working in repeater AP mode.
Log Select an AP and click this button to go to the Monitor > Log > View AP Log screen to view
the selected AP's current log messages.
Suppression On Select an AP and click this button to enable the AP's LED suppression mode. All the LEDs of
the AP will turn off after the AP is ready. This button is not available if the selected AP
doesn't support suppression mode.
Suppression Off Select an AP and click this button to disable the AP's LED suppression mode. The AP LEDs
stay lit after the AP is ready. This button is not available if the selected AP doesn't support
suppression mode.
# This field is a sequential value, and it is not associated with any entry.
IP Address This field displays the IP address of the AP.
MAC Address This field displays the MAC address of the AP.
Model This field displays the AP's hardware model information. It displays N/A (not applicable) only
when the AP disconnects from the Zyxel Device and the information is unavailable as a
result.
R1 Mode / Profile / This field displays the operating mode (AP, MON, rootap, or repeater), AP radio profile name
ZyMesh Profile and ZyMesh profile name for Radio 1. It displays - for the ZyMesh profile for a radio not using
a ZyMesh profile.
R2 Mode / Profile / This field displays the operating mode (AP, MON, rootap, or repeater), AP radio profile name
ZyMesh Profile and ZyMesh profile name for Radio 2. It displays - for the ZyMesh profile for a radio not using
a ZyMesh profile.
Group This field displays the name of the AP group to which the AP belongs.
The group becomes editable immediately upon clicking.
Mgnt. VLAN ID(AC) This displays the Access Controller (the Zyxel Device) management VLAN ID setting for the
AP.
Mgnt. VLAN ID(AP) This displays the runtime management VLAN ID setting on the AP. VLAN Conflict displays if
the AP's management VLAN ID does not match the Mgnt. VLAN ID(AC). This field displays n/
a if the Zyxel Device cannot get VLAN information from the AP.
Description This field displays the AP's description, which you can configure by selecting the AP's entry
and clicking the Edit button.
Chapter 8 Wireless
Type to Always Accept, then as soon as you remove an AP from this list it
reconnects.
APs can use DCS.
ZyWALL ATP Series User's Guide
186