ZyXEL Communications ZyWall ATP series User Manual page 131

Table 36 Monitor > System Status > Cellular Status (continued)
LABEL
Status
Service Provider
Chapter 6 Monitor
DESCRIPTION
• No device - no mobile broadband device is connected to the Zyxel Device.
• No Service - no mobile broadband network is available in the area; you cannot
connect to the Internet.
• Limited Service - returned by the service provider in cases where the SIM card is
expired, the user failed to pay for the service and so on; you cannot connect to
the Internet.
• Device detected - displays when you connect a mobile broadband device.
• Device error - a mobile broadband device is connected but there is an error.
• Probe device fail - the Zyxel Device's test of the mobile broadband device failed.
• Probe device ok - the Zyxel Device's test of the mobile broadband device
succeeded.
• Init device fail - the Zyxel Device was not able to initialize the mobile broadband
device.
• Init device ok - the Zyxel Device initialized the mobile broadband card.
• Check lock fail - the Zyxel Device's check of whether or not the mobile
broadband device is locked failed.
• Device locked - the mobile broadband device is locked.
• SIM error - there is a SIM card error on the mobile broadband device.
• SIM locked-PUK - the PUK is locked on the mobile broadband device's SIM card.
• SIM locked-PIN - the PIN is locked on the mobile broadband device's SIM card.
• Unlock PUK fail - Your attempt to unlock a WCDMA mobile broadband device's
PUK failed because you entered an incorrect PUK.
• Unlock PIN fail - Your attempt to unlock a WCDMA mobile broadband device's
PIN failed because you entered an incorrect PIN.
• Unlock device fail - Your attempt to unlock a CDMA2000 mobile broadband
device failed because you entered an incorrect device code.
• Device unlocked - You entered the correct device code and unlocked a
CDMA2000 mobile broadband device.
• Get dev-info fail - The Zyxel Device cannot get cellular device information.
• Get dev-info ok - The Zyxel Device succeeded in retrieving mobile broadband
device information.
• Searching network - The mobile broadband device is searching for a network.
• Get signal fail - The mobile broadband device cannot get a signal from a network.
• Network found - The mobile broadband device found a network.
• Apply config - The Zyxel Device is applying your configuration to the mobile
broadband device.
• Inactive - The mobile broadband interface is disabled.
• Active - The mobile broadband interface is enabled.
• Incorrect device - The connected mobile broadband device is not compatible
with the Zyxel Device.
• Correct device - The Zyxel Device detected a compatible mobile broadband
device.
• Set band fail - Applying your band selection was not successful.
• Set band ok - The Zyxel Device successfully applied your band selection.
• Set profile fail - Applying your ISP settings was not successful.
• Set profile ok - The Zyxel Device successfully applied your ISP settings.
• PPP fail - The Zyxel Device failed to create a PPP connection for the cellular
interface.
• Need auth-password - You need to enter the password for the mobile broadband
card in the cellular edit screen.
• Device ready - The Zyxel Device successfully applied all of your configuration and
you can use the mobile broadband connection.
This displays the name of your network service provider. This shows Limited Service if
the service provider has stopped service to the mobile broadband card. For example
if the bill has not been paid or the account has expired.
ZyWALL ATP Series User's Guide
131