ZyXEL Communications ZyWall ATP series User Manual page 747

Table 330 ZON Utility Icons
ICON
3 Reboot Device
4 Reset Configuration to
Default
5 Locator LED
6 Web GUI
7 Firmware Upgrade
8 Change Password
9 Configure NCC
Discovery
10 ZAC
11 Clear and Rescan
12 Save Configuration
13 Settings
The following table describes the fields in the ZON Utility main screen.
Table 331 ZON Utility Fields
LABEL
Type
Model
Firmware Version
MAC Address
IP Address
System Name
Location
Status
NCC Discovery
Serial Number
Hardware Version
Chapter 37 System
DESCRIPTION
Use this icon to restart the selected device(s). This may be useful when troubleshooting
or upgrading new firmware.
If you forget your password or cannot access the Web Configurator, you can use this
icon to reload the factory-default configuration file. This means that you will lose all
configurations that you had previously.
Use this icon to locate the selected device by causing its Locator LED to blink.
Use this to access the selected device web configurator from your browser. You will
need a username and password to log in.
Use this icon to upgrade new firmware to selected device(s) of the same model. Make
sure you have downloaded the firmware from the Zyxel website to your computer and
unzipped it in advance.
Use this icon to change the admin password of the selected device. You must know
the current admin password before changing to a new one.
You must have Internet access to use this feature. Use this icon to enable or disable
the Nebula Control Center (NCC) discovery feature on the selected device. If it's
enabled, the selected device will try to connect to the NCC. Once the selected
device is connected to and has registered in the NCC, it'll go into the cloud
management mode.
Use this icon to run the Zyxel AP Configurator of the selected AP.
Use this icon to clear the list and discover all devices on the connected network
again.
Use this icon to save configuration changes to permanent memory on a selected
device.
Use this icon to select a network adaptor for the computer on which the ZON utility is
installed, and the utility language.
DESCRIPTION
This field displays an icon of the kind of device discovered.
This field displays the model name of the discovered device.
This field displays the firmware version of the discovered device.
This field displays the MAC address of the discovered device.
This field displays the IP address of an internal interface on the discovered device that
first received an ZDP discovery request from the ZON utility.
This field displays the system name of the discovered device.
This field displays where the discovered device is.
This field displays whether changes to the discovered device have been done
successfully. As the Zyxel Device does not support IP Configuration, Renew IP address
and Flash Locator LED, this field displays "Update failed", "Not support Renew IP
address" and "Not support Flash Locator LED" respectively.
This field displays if the discovered device supports the Nebula Control Center (NCC)
discovery feature. If it's enabled, the selected device will try to connect to the NCC.
Once the selected device is connected to and has registered in the NCC, it'll go into
the cloud management mode.
Enter the admin password of the discovered device to display its serial number.
This field displays the hardware version of the discovered device.
ZyWALL ATP Series User's Guide
747