Host Name; Usb Storage - ZyXEL Communications ZyWall ATP series User Manual

• Use the System > IPv6 screen (see
Zyxel Device.
• Use the System > ZON screen (see
Network (ZON) utility that uses Zyxel Discovery Protocol (ZDP) for discovering and configuring ZDP-
aware Zyxel devices in the same network as the computer on which ZON is installed.
Note: See each section for related background information and term definitions.

37.2 Host Name

A host name is the unique name by which a device is known on a network. Click Configuration > System
> Host Name to open the Host Name screen.
Figure 455 Configuration > System > Host Name
The following table describes the labels in this screen.
Table 299 Configuration > System > Host Name
LABEL
System Name
Domain Name
Apply
Reset

37.3 USB Storage

The Zyxel Device can use a connected USB device to store the system log and other diagnostic
information. Use this screen to turn on this feature and set a disk full warning limit.
Note: Only connect one USB device. It must allow writing (it cannot be read-only) and use the
FAT16, FAT32, EXT2, or EXT3 file system.
Chapter 37 System
Section 37.16 on page
Section 37.17 on page
DESCRIPTION
Enter a descriptive name to identify your Zyxel Device device. This name can be up to 64
alphanumeric characters long. Spaces are not allowed, but dashes (-) underscores (_) and
periods (.) are accepted.
Enter the domain name (if you know it) here. This name is propagated to DHCP clients
connected to interfaces with the DHCP server enabled. This name can be up to 254
alphanumeric characters long. Spaces are not allowed, but dashes "-" are accepted.
Click Apply to save your changes back to the Zyxel Device.
Click Reset to return the screen to its last-saved settings.
ZyWALL ATP Series User's Guide
743) to enable or disable IPv6 support on the
744) to enable or disable the Zyxel One
690