ZyXEL Communications ZyWall ATP series User Manual page 731

Figure 498 Configuration > System > FTP
The following table describes the labels in this screen.
Table 318 Configuration > System > FTP
LABEL DESCRIPTION
Enable Select the check box to allow or disallow the computer with the IP address that matches the IP
address(es) in the Service Control table to access the Zyxel Device using this service.
TLS required Select the check box to use FTP over TLS (Transport Layer Security) to encrypt communication.
This implements TLS as a security mechanism to secure FTP clients and/or servers.
Server Port You may change the server port number for a service if needed, however you must use the
same port number in order to use that service for remote management.
Server Certificate Select the certificate whose corresponding private key is to be used to identify the Zyxel Device
for FTP connections. You must have certificates already configured in the My Certificates
screen.
Service Control This specifies from which computers you can access which Zyxel Device zones.
Add Click this to create a new entry. Select an entry and click Add to create a new entry after the
selected entry. Refer to
Edit Double-click an entry or select it and click Edit to be able to modify the entry's settings.
Remove To remove an entry, select it and click Remove. The Zyxel Device confirms you want to remove
it before doing so. Note that subsequent entries move up by one when you take this action.
Move To change an entry's position in the numbered list, select the method and click Move to display
a field to type a number for where you want to put it and press [ENTER] to move the rule to the
number that you typed.
# This the index number of the service control rule.
The entry with a hyphen (-) instead of a number is the Zyxel Device's (non-configurable) default
policy. The Zyxel Device applies this to traffic that does not match any other configured rule. It
is not an editable rule. To apply other behavior, configure a rule that traffic will match so the
Zyxel Device will not have to use the default policy.
Zone This is the zone on the Zyxel Device the user is allowed or denied to access.
Address This is the object name of the IP address(es) with which the computer is allowed or denied to
access.
Action This displays whether the computer with the IP address specified above can access the Zyxel
Device zone(s) configured in the Zone field (Accept) or not (Deny).
Chapter 37 System
Table 312 on page 711
ZyWALL ATP Series User's Guide
731
for details on the screen that opens.