View Log - ZyXEL Communications ZyWall ATP series User Manual

Table 295 Configuration > Device HA > Device HA Pro (continued)
LABEL
Password
Retype to Confirm
Heartbeat Interval
Heartbeat Lost Tolerance
Monitor Interface
Failover Detection
Enable Failover When
Interface Failure
(Option)
Enable Failover When
Device Service Fails
(Option)
Apply
Reset

35.4 View Log

Use this screen to see Device HA Pro logs on the active and passive Zyxel Devices.
Go to Configuration > Device HA > View Log to display the following screen.
Chapter 35 Device HA
DESCRIPTION
Type a synchronization password of between 1 and 32 single-byte printable
characters. You will be prompted for the password before synchronization takes
place.
Type the exact same synchronization password as typed above.
Type the number of seconds (1-10) allowed for absence of a heartbeat signal
before a failure of the active Zyxel Device is recorded.
Type the number of heartbeat failures allowed before failover is activated on the
passive Zyxel Device.
Select an interface in Available Interfaces and click the right-arrow button to move
it to Monitor Interface to become a Device HA pro monitored interface. To remove
a Device HA pro monitored interface, select it in Monitor Interface and click the left-
arrow button to move it to Available Interfaces.
Select this to have the passive Zyxel Device take over when a monitored interface
fails.
Select this to have the passive Zyxel Device take over when a monitored service
daemon on the active Zyxel Device fails.
Click Apply to save your Device HA Pro configurations back to the Zyxel Device but
keep the Zyxel Device using Device HA (general).
Click Reset to return the screen to its last-saved settings.
ZyWALL USG Series User's Guide
680