User/Group Group Summary Screen - ZyXEL Communications ZyWall ATP series User Manual

Table 236 Configuration > Object > User/Group > User > Add (continued)
LABEL
Description
Email
Mobile Number
Authentication
Timeout Settings
Lease Time
Reauthentication
Time
User VLAN ID
Configuration
Validation
OK
Cancel

34.2.3 User/Group Group Summary Screen

User groups consist of access users and other user groups. You cannot put admin users in user groups.
The Group screen provides a summary of all user groups. In addition, this screen allows you to add, edit,
and remove user groups. To access this screen, login to the Web Configurator, and click Configuration >
Object > User/Group > Group.
Chapter 34 Object
DESCRIPTION
Enter the description of each user, if any. You can use up to 60 printable ASCII characters.
Default descriptions are provided.
Type one or more valid email addresses for this user so that email messages can be sent to
this user if required. A valid email address must contain the @ character. For example, this is
a valid email address: abc@example.com.
Type a valid mobile telephone number for this user so that SMS messages can be sent to this
user if required. A valid mobile telephone number can be up to 20 characters in length,
including the numbers 1~9 and the following characters in the square brackets [+*#()-].
If you want the system to use default settings, select Use Default Settings. If you want to set
authentication timeout to a value other than the default settings, select Use Manual Settings
then fill your preferred values in the fields that follow.
If you select Use Default Settings in the Authentication Timeout Settings field, the default
lease time is shown.
If you select Use Manual Settings, you need to enter the number of minutes this user has to
renew the current session before the user is logged out. You can specify 1 to 1440 minutes.
You can enter 0 to make the number of minutes unlimited. Admin users renew the session
every time the main screen refreshes in the Web Configurator. Access users can renew the
session by clicking the Renew button on their screen. If you allow access users to renew time
automatically (see Section 34.2.4 on page
screen as well. In this case, the session is automatically renewed before the lease time
expires.
If you select Use Default Settings in the Authentication Timeout Settings field, the default
lease time is shown.
If you select Use Manual Settings, you need to type the number of minutes this user can be
logged into the Zyxel Device in one session before the user has to log in again. You can
specify 1 to 1440 minutes. You can enter 0 to make the number of minutes unlimited. Unlike
Lease Time, the user has no opportunity to renew the session without logging out.
This field is available for a ext-group-user type user account.
Select this option to enable dynamic VLAN assignment on the Zyxel Device. When a user is
authenticated successfully, all data traffic from this user is tagged with the VLAN ID number
you specify here.
This allows you to assign a user of the ext-group-user type to a specific VLAN based on the
user credentials instead of using an AAA server.
Use a user account from the group specified above to test if the configuration is correct.
Enter the account's user name in the User Name field and click Test.
Click OK to save your changes back to the Zyxel Device.
Click Cancel to exit this screen without saving your changes.
ZyWALL ATP Series User's Guide
587
589), the users can select this check box on their