Rack-Mounting; Wall-Mounting - ZyXEL Communications ZyWall ATP series User Manual

3.2.1 Rack-mounting

Use the following steps to mount the Zyxel Device on an EIA standard size, 19-inch rack or in a wiring
closet with other equipment using a rack-mounting kit. Make sure the rack will safely support the
combined weight of all the equipment it contains and that the position of the ZyWALL does not make
the rack unstable or top-heavy. Take all necessary precautions to anchor the rack securely before
installing the unit.
Note: Leave 10 cm of clearance at the sides and 20 cm in the rear.
Use a #2 Phillips screwdriver to install the screws.
Note: Failure to use the proper screws may damage the unit.
Align one bracket with the holes on one side of the Zyxel Device and secure it with the included bracket
1
screws (smaller than the rack-mounting screws).
Attach the other bracket in a similar fashion.
2
After attaching both mounting brackets, position the Zyxel Device in the rack and match up the bracket
3
holes with the rack holes. Secure the Zyxel Device to the rack with the rack-mounting screws.

3.2.2 Wall-mounting

Do the following to attach your Zyxel Device to a wall.
Drill two holes 3 mm ~ 4 mm (0.12" ~ 0.16") wide, 20 mm ~ 30 mm (0.79" ~ 1.18") deep and 150 mm (5.90")
1
apart, into a wall. Place two screw anchors in the holes.
Chapter 3 Hardware, Interfaces and Zones
ZyWALL ATP Series User's Guide
67