ZyXEL Communications ZyWall ATP series User Manual page 622

Table 258 Configuration > Object > Address/Geo IP > Address (continued)
LABEL
Reference
IPv6 Address Configuration
Add
Edit
Remove
References
#
Name
Type
IPv6 Address
Reference
34.6.2.1 IPv4 Address Add/Edit Screen
The Configuration > Object > Address/GeoIP > Address > Add/Edit (IPv4) screen allows you to create a
new address or edit an existing one. To access this screen, go to the Address screen (see
on page 620), and click either the Add icon or an Edit icon in the IPv4 Address Configuration section.
Figure 403 Configuration > Object > Address/GeoIP > Address > Add/Edit (IPv4) t
The following table describes the labels in this screen.
Table 259 Configuration > Object > Address/GeoIP > Address > Add/Edit (IPv4)
LABEL
Name
Address Type
IP Address
Starting IP
Address
Chapter 34 Object
DESCRIPTION
This displays the number of times an object reference is used in a profile.
Click this to create a new entry.
Double-click an entry or select it and click Edit to be able to modify the entry's settings.
To remove an entry, select it and click Remove. The Zyxel Device confirms you want to remove
it before doing so.
Select an entry and click References to open a screen that shows which settings use the entry.
This field is a sequential value, and it is not associated with a specific address.
This field displays the configured name of each address object.
This field displays the type of each address object. "INTERFACE" means the object uses the
settings of one of the Zyxel Device's interfaces.
This field displays the IPv6 addresses represented by each address object. If the object's
settings are based on one of the Zyxel Device's interfaces, the name of the interface displays
first followed by the object's current address settings.
This displays the number of times an object reference is used in a profile.
DESCRIPTION
Type the name used to refer to the address. You may use 1-31 alphanumeric characters,
underscores( ), or dashes (-), but the first character cannot be a number. This value is case-
_
sensitive.
Select the type of address you want to create.
Note: The Zyxel Device automatically updates address objects that are based on an
interface's IP address, subnet, or gateway if the interface's IP address settings
change. For example, if you change 1's IP address, the Zyxel Device
automatically updates the corresponding interface-based, LAN subnet
address object.
This field is only available if the Address Type is HOST. This field cannot be blank. Enter the IP
address that this address object represents.
This field is only available if the Address Type is RANGE. This field cannot be blank. Enter the
beginning of the range of IP addresses that this address object represents.
ZyWALL ATP Series User's Guide
622
Section 34.6.2