ZyXEL Communications ZyWall ATP series User Manual page 754

Figure 520 Configuration > Log & Report > Log Setting > Edit (System Log - AP)
The following table describes the labels in this screen.
Table 335 Configuration > Log & Report > Log Setting > Edit (System Log)
LABEL DESCRIPTION
E-Mail Server 1/2
Active Select this to send log messages and alerts according to the information in this section.
You specify what kinds of log messages are included in log information and what kinds of
log messages are included in alerts in the Active Log and Alert section.
Mail Server Type the name or IP address of the outgoing SMTP server.
Mail Server Port Enter the same port number here as is on the mail server for mail traffic.
Mail Subject Type the subject line for the outgoing email.
Send From Type the email address from which the outgoing email is delivered. This address is used in
replies.
Send Log To Type the email address to which the outgoing email is delivered.
Send Alerts To Type the email address to which alerts are delivered.
Sending Log Select how often log information is emailed. Choices are: When Full, Hourly and When Full,
Daily and When Full, and Weekly and When Full.
Day for Sending This field is available if the log is emailed weekly. Select the day of the week the log is
Log
emailed.
Time for Sending This field is available if the log is emailed weekly or daily. Select the time of day (hours and
Log
minutes) when the log is emailed. Use 24-hour notation.
SMTP Select this check box if it is necessary to provide a user name and password to the SMTP
Authentication
server.
User Name This box is effective when you select the SMTP Authentication check box. Type the user
name to provide to the SMTP server when the log is emailed.
Password This box is effective when you select the SMTP Authentication check box. Type the
password to provide to the SMTP server when the log is emailed.
Retype to Confirm Type the password again to make sure that you have entered is correctly.
Active Log and Alert
System Log Use the System Log drop-down list to change the log settings for all of the log categories.
disable all logs (red X) - do not log any information for any category for the system log or
email any logs to email server 1 or 2.
enable normal logs (green check mark) - create log messages and alerts for all
categories for the system log. If email server 1 or 2 also has normal logs enabled, the Zyxel
Device will email logs to them.
enable normal logs and debug logs (yellow check mark) - create log messages, alerts,
and debugging information for all categories. The Zyxel Device does not email
debugging information, even if this setting is selected.
Chapter 38 Log and Report
ZyWALL ATP Series User's Guide
754