Ppp Interface Add Or Edit - ZyXEL Communications ZyWall ATP series User Manual

Each field is described in the table below.
Table 97 Configuration > Network > Interface > PPP
LABEL
User Configuration /
System Default
Add
Edit
Remove
Activate
Inactivate
Connect
Disconnect
References
#
Status
Name
Base Interface
Account Profile
Apply
Reset

9.4.2 PPP Interface Add or Edit

Note: You have to set up an ISP account before you create a PPPoE/PPTP/
This screen lets you configure a PPPoE or PPTP or L2TP interface. If you enabled IPv6 in the Configuration
> System > IPv6 screen, you can also configure PPP interfaces used for your IPv6 networks on this screen.
To access this screen, click the Add icon or an Edit icon in the PPP Interface screen.
Chapter 9 Interfaces
DESCRIPTION
The Zyxel Device comes with the (non-removable) System Default PPP interfaces pre-
configured. You can create (and delete) User Configuration PPP interfaces. System Default
PPP interfaces vary by model.
Click this to create a new user-configured PPP interface.
Double-click an entry or select it and click Edit to open a screen where you can modify the
entry's settings.
To remove a user-configured PPP interface, select it and click Remove. The Zyxel Device
confirms you want to remove it before doing so.
To turn on an entry, select it and click Activate.
To turn off an entry, select it and click Inactivate.
To connect an interface, select it and click Connect. You might use this in testing the
interface or to manually establish the connection for a Dial-on-Demand PPPoE/PPTP
interface.
To disconnect an interface, select it and click Disconnect. You might use this in testing the
interface.
Select an entry and click References to open a screen that shows which settings use the
entry. See Section 9.3.4 on page 230
This field is a sequential value, and it is not associated with any interface.
The activate (light bulb) icon is lit when the entry is active and dimmed when the entry is
inactive.
The connect icon is lit when the interface is connected and dimmed when it is
disconnected.
This field displays the name of the interface.
This field displays the interface on the top of which the PPPoE/PPTP/L2TP interface is.
This field displays the ISP account used by this PPPoE/PPTP interface.
Click Apply to save your changes back to the Zyxel Device.
Click Reset to return the screen to its last-saved settings.
ZyWALL ATP Series User's Guide
235
for an example.
interface.
L2TP