Telnet; Configuring Telnet - ZyXEL Communications ZyWall ATP series User Manual

Figure 494 SSH Example 2: Test

$ telnet 192.168.1.1 22

Trying 192.168.1.1...
Connected to 192.168.1.1.
Escape character is '^]'.
SSH-1.5-1.0.0
Enter "ssh –1 192.168.1.1". This command forces your computer to connect to the Zyxel Device
2
using SSH version 1. If this is the first time you are connecting to the Zyxel Device using SSH, a message
displays prompting you to save the host information of the Zyxel Device. Type "yes" and press [ENTER].
Then enter the password to log in to the Zyxel Device.
Figure 495 SSH Example 2: Log in
$ ssh –1 192.168.1.1
The authenticity of host '192.168.1.1 (192.168.1.1)' can't be established.
RSA1 key fingerprint is 21:6c:07:25:7e:f4:75:80:ec:af:bd:d4:3d:80:53:d1.
Are you sure you want to continue connecting (yes/no)? yes
Warning: Permanently added '192.168.1.1' (RSA1) to the list of known hosts.
Administrator@192.168.1.1's password:
The CLI screen displays next.
3
37.9 Telnet
You can use Telnet to access the Zyxel Device's command line interface. Specify which zones allow
Telnet access and from which IP address the access can come.

37.9.1 Configuring Telnet

Click Configuration > System > TELNET to configure your Zyxel Device for remote Telnet access. Use this
screen to specify from which zones Telnet can be used to manage the Zyxel Device. You can also
specify from which IP addresses the access can come.
Chapter 37 System
ZyWALL ATP Series User's Guide
728