Address Group Summary Screen - ZyXEL Communications ZyWall ATP series User Manual

Table 260 Configuration > Object > Address/GeoIP > Address > Add/Edit (IPv6)
LABEL
IPv6 Address
Prefix
Interface
IPv6 Address Type Select whether the IPv6 address is a link-local IP address (LINK LOCAL), static IP address
Country
FQDN
OK
Cancel

34.6.3 Address Group Summary Screen

The Address Group screen provides a summary of all address groups. To access this screen, click
Configuration > Object > Address/Geo IP > Address Group. Click a column's heading cell to sort the
table entries by that column's criteria. Click the heading cell again to reverse the sort order.
Figure 405 Configuration > Object > Address/Geo IP > Address Group
The following table describes the labels in this screen. See
information as well.
Table 261 Configuration > Object > Address/Geo IP > Address Group
LABEL
IPv4 Address Group Configuration
Add
Edit
Remove
References
#
Name
Description
Reference
IPv6 Address Group Configuration
Chapter 34 Object
DESCRIPTION
This field is only available if the Address Type is SUBNET. This field cannot be blank. Enter the IPv6
address prefix that the Zyxel Device uses for the LAN IPv6 address.
If you selected INTERFACE IP, INTERFACE SUBNET, or INTERFACE GATEWAY as the Address Type,
use this field to select the interface of the network that this address object represents.
(STATIC), an IPv6 StateLess Address Auto Configuration IP address (SLAAC), or is obtained from
a DHCPv6 server (DHCPv6).
If you selected Geography as the Address Type, use this field to select a country.
If you selected FQDN as the Address Type, use this field to enter a fully qualified domain name.
Click OK to save your changes back to the Zyxel Device.
Click Cancel to exit this screen without saving your changes.
DESCRIPTION
Click this to create a new entry.
Double-click an entry or select it and click Edit to be able to modify the entry's settings.
To remove an entry, select it and click Remove. The Zyxel Device confirms you want to remove
it before doing so.
Select an entry and click References to open a screen that shows which settings use the entry.
This field is a sequential value, and it is not associated with a specific address group.
This field displays the name of each address group.
This field displays the description of each address group, if any.
This displays the number of times an object reference is used in a profile.
ZyWALL ATP Series User's Guide
Section 34.6.3.1 on page 625
624
for more