ZyXEL Communications ZyWall ATP series User Manual page 286

Table 112 Configuration > Network > Interface > VTI > Add (continued)
LABEL DESCRIPTION
Check Timeout Enter the number of seconds to wait for a response before the attempt is a failure.
Check Fail Enter the number of consecutive failures before the Zyxel Device stops routing through the
Tolerance
gateway.
Check this Select this to specify a domain name or IP address for the connectivity check. Enter that
address
domain name or IP address in the field next to it.
Check Port This field only displays when you set the Check Method to tcp. Specify the port number to
use for a TCP connectivity check.
RIP Setting See
Enable RIP Select this to enable RIP in this interface.
Direction This field is effective when RIP is enabled. Select the RIP direction from the drop-down list
box.
BiDir - This interface sends and receives routing information.
In-Only - This interface receives routing information.
Out-Only - This interface sends routing information.
Send Version This field is effective when RIP is enabled. Select the RIP version(s) used for sending RIP
packets. Choices are 1, 2, and 1 and 2.
Receive Version This field is effective when RIP is enabled. Select the RIP version(s) used for receiving RIP
packets. Choices are 1, 2, and 1 and 2.
V2-Broadcast This field is effective when RIP is enabled. Select this to send RIP-2 packets using subnet
broadcasting; otherwise, the Zyxel Device uses multicasting.
OSPF Setting See
Area Select the area in which this interface belongs. Select None to disable OSPF in this interface.
Priority Enter the priority (between 0 and 255) of this interface when the area is looking for a
Designated Router (DR) or Backup Designated Router (BDR). The highest-priority interface
identifies the DR, and the second-highest-priority interface identifies the BDR. Set the priority
to zero if the interface can not be the DR or BDR.
Link Cost Enter the cost (between 1 and 65,535) to route packets through this interface.
Passive Interface Select this to stop forwarding OSPF routing information from the selected interface. As a
result, this interface only receives routing information.
Authentication Select an authentication method, or disable authentication. To exchange OSPF routing
information with peer border routers, you must use the same authentication method that
they use. Choices are:
Same-as-Area - use the default authentication method in the area
None - disable authentication
Text - authenticate OSPF routing information using a plain-text password
MD5 - authenticate OSPF routing information using MD5 encryption
Text This field is available if the Authentication is Text. Type the password for text authentication.
Authentication
The key can consist of alphanumeric characters and the underscore, and it can be up to 16
Key
characters long.
MD5 This field is available if the Authentication is MD5. Type the ID for MD5 authentication. The ID
Authentication ID
can be between 1 and 255.
MD5 This field is available if the Authentication is MD5. Type the password for MD5 authentication.
Authentication
The password can consist of alphanumeric characters and the underscore, and it can be
Key
up to 16 characters long.
Related Setting
Chapter 9 Interfaces
Section 10.6 on page 311 for more information about RIP.
Section 10.7 on page 313 for more information about OSPF.
ZyWALL ATP Series User's Guide
286